CycloCar 23

¬ In-grade luminaire for landscape lighting. The luminaire is fully adjustable up to 360° horizontal rotation after installation. Suitable for drive-over applications (maximum load 6600 lbs.). Available in 10.5” diameter.
¬ Self extinguishing (V2 rated), injection molded polypropylene rough-in housing to house the luminaire. Includes a die-cast anodized aluminum, 24 cu. in. integral junction box, secured and sealed against water intrusion to the bottom of the rough-in with two 1/2” NPT openings for feed through wiring.
¬ Luminaire housing is stainless steel AISI 304, dark gray satin finish. Precision die cast, copper free aluminum faceplate, 0.3” thick. Conforms to ASTM A413.2. Polished natural aluminum or black anodized finish.
¬ Retaining ring is stainless steel AlSI 304, dark gray satin finish, 0,1” thick.
¬ Molded soda lime glass diffuser, 0,2” thick, resistant to thermal shocks.
¬ The diffuser is held in place by the retaining ring, which is secured by six stainless steel set screws.
¬ One-piece molded silicone gasket seals out water and dust.
¬ Aluminum upper and lower sections separated by aluminum spacers. The lower section houses the electrical gear while the upper one sustains the optical compartment. Aluminum reflector. Grounded internally.
¬ Cyclocar 23 has a +/- 25° adjustable lamp reflector tilt, secured by two Philips head screws to maintain aiming during relamping. Full 360° horizontal rotation.
¬ The luminaire is factory wired with 24” of #18-3 AWG SJEOW cord. The cord is sufficient to allow the luminaire housing to be removed from the rough-in housing for inspection, cleaning or relamping .
¬ The cord ends are factory sealed with resin compound to the luminaire housing and to the junction box cover. The cast aluminum junction box cover includes an O-ring gasket to ensure water tightness. Wire is resin glued to the cover to create a siphon barrier.
¬ UL and cUL listed for wet location, IP67: suitable for temporary submersion. Suitable for in-ground and concrete mount.